POWER VERSION
9.
If you have a solar panel, clamp the panel to the drive motor end frame and plug into ‘Solar’ connector socket on
the underside of the control housing
10.
Adjust the solar panel so it is facing the sun at midday (or at the meantime your solar panel receives full sun).
This will ensure the optimum solar panel position for your location.
If your solar panel is not in direct sunlight for the majority of the day you will need to recharge the battery using the
AC charger. The regularity of recharging using AC charger will be determined by the amount of sun the PV panel
receives and your roller usage
Note: If you do not have enough sunlight on the solar panel to maintain battery voltage, consider the #1262 PV Post
Extension kit that comes with a 5m extension cord and post to insert into the ground that solar panel clamps to
11.
Plug in AC Charger to fully charge battery before first operation.
Operation:
General
Forward and reverse buttons control the drive motor direction
Remote control operation is the same operation as the buttons on the control housing. Control button and remote
button will only operate the motor while the button is being pressed
Ensure the AC charger pack is not exposed to water or weather.
Plug in AC charger into the AC Charger connection to re charge battery
To free wheel the roller tube, disengage the motor drive by lifting the locking pin – lift up to free wheel (rocking the
tube back or forward may be required to take the weight off the pin to disengage)
9.
Clamp the panel to the drive motor end frame and plug into
‘Solar’ connector socket on the underside of the control
housing.
6.
Install the tube motor onto the end frame,
secure firmly 4x mounting bolts.
Important:
Make sure recess is facing DOWN when
mounting to frame to avoid water filling up inside.
7.
Install the control housing, secure firmly the
4x mounting bolts.
5.
Ensure drive motor wire is running through the recess in the housing on the drive motor end, be careful not to
pinch wire when mounting.
6.
Install the tube motor onto end frame, secure firmly 4 x mounting bolts
Important: make sure recess is facing DOWN when mounting to frame to avoid water filling up inside
7.
Install the control housing, secure firmly the 4 x mounting bolts
8.
Plug in the drive motor wire to the connector socket on the underside of the control housing
Note: each connector socket has labels for the correct appliance
8.
Plug in the drive motor wire to the connector socket on the
underside of the control housing.
Note:
Each connector socket has labels for the
correct appliance.
10.
Adjust the solar panel so it is facing the sun at midday (or
at the meantime your solar panel receives full sun). This will
ensure the optimum solar panel position for your location.
If your solar panel is not in direct sunlight for the majority of
the day, you will need to recharge the battery using the AC
charger. The regularity of recharging using the AC charger
will be determined by the amount of sun the PV panel
receives and your roller usage.
Note:
If you do not have enough sunlight on the solar panel
to maintain battery voltage, consider the #1262 PV Post
Extension kit that comes with a 5m extension cord and post
to insert into the ground that the solar panel clamps to.
11.
Plug in AC Charger to fully charge battery before first
operation.
