31
English
Fault diagnosis.
Fault diagnosis by remote controller
The remote controller can receive a corresponding error code from the indoor unit.
When
1.
is held down for 5 seconds, a “ ” indication blinks on the temperature display section.
Press
2.
repeatedly until a continuous beep is produced.
The code indication changes as displayed in the following table, and noti
fi
es with a long beep.
•
CODE
MEANING
SYSTEM
00
NORMAL
U0
REFRIGERANT SHORTAGE
U2
DROP VOLTAGE OR MAIN CIRCUIT OVERVOLTAGE
U4
FAILURE OF TRANSMISSION (BETWEEN INDOOR UNIT AND OUTDOOR UNIT)
INDOOR
UNIT
A1
INDOOR PCB DEFECTIVENESS
A5
HIGH PRESSURE CONTROL OR FREEZE-UP PROTECTOR
A6
FAN MOTOR FAULT
C4
FAULTY HEAT EXCHANGER TEMPERATURE SENSOR
C9
FAULTY SUCTION AIR TEMPERATURE SENSOR
OUTDOOR
UNIT
EA
COOLING-HEATING SWITCHING ERROR
E5
OL STARTED
E6
FAULTY COMPRESSOR START UP
E7
DC FAN MOTOR FAULT
E8
OVERCURRENT INPUT
F3
HIGH TEMPERATURE DISCHARGE PIPE CONTROL
H6
OPERATION HALT DUE TO FAULTY POSITION DETECTION SENSOR
H8
DC CURRENT SENSOR FAULT
H9
FAULTY SUCTION AIR TEMPERATURE SENSOR
J3
FAULTY DISCHARGE PIPE TEMPERATURE SENSOR
J6
FAULTY HEAT EXCHANGER TEMPERATURE SENSOR
L4
HIGH TEMPERATURE AT INVERTER CIRCUIT HEATSINK
L5
OUTPUT OVERCURRENT
P4
FAULTY INVERTER CIRCUIT HEATSINK TEMPERATURE SENSOR
NOTE
A short beep and two consecutive beeps indicate non-corresponding codes.
•
To cancel the code display, hold
•
for 5 seconds. The code display also cancel itself if the button is not pressed for
1 minute.
TIMER CANCEL button
Cancels the timer setting.
01_EN_3P232717-3D.indd 31
01_EN_3P232717-3D.indd 31
10/6/2009 9:21:23 AM
10/6/2009 9:21:23 AM
