24
Care and Cleaning
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker off.
Units
Indoor unit, outdoor unit and remote controller
Wipe them with a soft cloth when dirty.
Front panel
Open the front panel.
1.
Hold the front panel by the panel tabs on the both sides
•
and open it.
Remove the front panel.
2.
Slide the front panel to either the left or right and pulling it
•
toward you.
This will disconnect the rotation dowel on one side.
Disconnect the front panel shaft on the other side in the
•
same manner.
Clean the front panel.
3.
Wipe it with a soft cloth soaked in water.
•
Only neutral detergent may be used.
•
If you wash the panel with water, wipe it with a dry soft cloth, and allow to dry in the shade.
•
Attach the front panel.
4.
Align the front panel shaft on the left and right of the front panel with the slots,
•
then push them all the way in.
Close the front panel slowly. (Press the panel at both sides and the center.)
•
CAUTION
When the packaging materials are attached to the front panel, please remove them.
•
Do not touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 104°F (40°C), benzine, gasoline, thinner, nor other volatile oils,
•
polishing compound, scrubbing brushes, nor other hand stuff.
After cleaning, make sure that the front panel is securely
fi
xed.
•
01_EN_3P232717-3D.indd 24
01_EN_3P232717-3D.indd 24
10/6/2009 9:21:19 AM
10/6/2009 9:21:19 AM
