Daikin SkyAir FTQ18TAVJUA, Руководство по эксплуатации

Страница: 8 / 16

8 English
4. To change the fan speed, press the Fan speed control button
and select the desired fan speed from Low, Medium, or High.
• Only two fan speed adjustment levels, low and high may
be available depending on the type of Indoor unit.
• The system may be in automatic fan speed control for
equipment protection purposes.
• The system may be in automatic fan speed control
according to the room temperature. It is normal for the
fan to intermittently stop operating.
• It is normal for a delay to occur when changing the
fan speed.
5. Adjust Air Flow Direction from the Main Menu.
• If the connected indoor unit model does not include
oscillating louvers this function will not be available.
6. When the On/Off Button is pressed again, the system will
stop operating and the operation lamp will turn off.
• When the system is stopped while in the heating mode,
the fan will continue to operate for approximately one
minute to remove residual heat from the indoor unit.
NOTE: To prevent water damage or system failure, do not
immediately remove power from the indoor unit following
system operation. Wait at least five minutes for the condensate
pump to finish draining residual water from the unit.
CHARACTERISTICS OF HEAT MODE
The system automatically controls the following operating modes
to prevent the reduction of heating capacity and space comfort.
Defrost Operation
• The system will automatically go into defrost operation to
prevent frost accumulation at the outdoor unit and loss of
heating capacity.
• The indoor unit fan will stop, and “ STANDBY ” (Defrost/Hot
Start) will be displayed on the remote controller.
• The system will return to normal operation usually within six
to eight minutes (but not more than 10 minutes).
Hot Start
•
When the system goes into heat mode, the indoor unit fan
will stop in order to prevent a cold draft. (In that case,
“STANDBY” (Defrost/Hot Start) will be displayed on the
remote controller).
DRY MODE
Preparation
• For equipment protection purposes, apply power to the
outdoor units at least six hours before“starting the operation
of the system.
• The dry mode may not be selected if the remote controller is
master controlled and the system is not already in the cooling
mode of operation.
Operation
1. Press Mode Button several times until the Dry mode is
selected. (The Dry mode may not be available depending
on the type of indoor unit.)
2. Press On/Off Button. The Operation Lamp (green) will
illuminate and the system will start operating. In Dry Mode,
the system maintains automatic temperature and fan speed
control. Therefore, temperature setpoint or fan speed
settings are not available while the indoor unit is in the Dry
Mode.