Daikin SkyAir FTQ18TAVJUA, Руководство по эксплуатации

Страница: 11 / 16

11 English
• Press the Up/Down buttons to select “Reset Filter
Indicator” on the Main Menu screen and press the Menu/
Enter button.
• The display shown in the illustration will disappear from
the basic screen when the filter sign is reset.
START UP AFTER A LONG STOP
1. Confirm the following:
• Check that the air inlet and outlet are not blocked.
• Remove any obstacle
• Check if the ground is connected. Might there be a
broken wire somewhere?
• Contact a dealer if there are any problems.
2. Clean the air filter.
• After cleaning the air filter, make sure to attach it.
3. Turn on the main power supply switch
• The display on the remote controller will be shown when
the power is turned on.
• To protect the unit, turn on the main power switch at
least 6 hours before operation.
WHAT TO DO WHEN STOPPING THE SYSTEM FOR
A LONG PERIOD
1. Turn on FAN OPERATION for a half day and dry the unit.
• Read the operation manual that came with the remote
controller.
2. Shut off the power supply.
• When the main power switch is shut on, some watts of
electricty is being used even if the system is not operating.
• Turn off the main power supply switch for saving energy.
• The display on the remote controller will vanish when
the main power switch is turned off.
3. Clean the air filter and the exterior.
• Be sure to replace the air filter to its original place after
cleaning. Refer to “HOW TO CLEAN THE AIR FILTER.”
ELECTRICAL HEATER REPLACEMENT INTERVAL
• The electric heater should be replaced every 10 years.
• This replacement interval is a guideline for ensuring safe
and trouble-free operation of the product for many years.
9. MALFUNCTIONS NOT RELATED TO HEAT
PUMP
The following symptoms do not indicate heat pump malfunction:
I. THE SYSTEM DOES NOT OPERATE
• The system does not restart immediately after the ON/
OFF button is pressed.
If the OPERATION lamp lights,
the system is in normal condition. It does not restart
immediately because a safety device operates to prevent
overload of the system. After 3 minutes, the system will turn
on again automatically.
• The system does not restart immediately when
TEMPERATURE SETTING button is returned to the
former position after pushing the button.
If the
OPERATION lamp lights, the system is in normal condition.
It does not restart immediately because a safety device
operates to prevent overload of the system. After 3 minutes,
the system will turn on again automatically.
• The system does not start when the display shows
“CENTRAL CONTROL” and it flashes for few seconds
after pressing an operation button.
This is because the
system is under centralized control. Flashes on the display
indicate that the system cannot be controlled by the remote
controller.
• The system does not start immediately after the power
supply is turned on.
Wait one minute until the micro
computer is prepared for operation.
II. The fan speed is different from the setting.
• Pressing the fan speed control button does not change
the fan speed.
• When the room temperature reaches the set temperature in
heating mode, the outdoor unit stops and the indoor unit
switches to whisper mode. This is to prevent the cool air
from being blown directly onto anyone in the room.
• To protect electric parts, the unit operates with the airflow
rate at H speed during ELECTRIC HEATER operation
regardless of the remote controller indication.
III. WHITE MIST COMES OUT OF A UNIT
• When humidity is high during cooling operation (In oily
or dusty places)
If the inside of an indoor unit is extremely
contaminated, the temperature distribution inside a room
becomes uneven. It is necessary to clean the inside of the
indoor unit. Ask your Daikin dealer for details on cleaning
the unit. This operation requires a qualified service person.