Daikin RZQG71~140L7V1B, Руководство по обслуживанию

Страница: 99 / 279

Wireless Remote Controller ESIE12-06
88 Remote Controller
3P107422-31W
1
2
3
DISPLAY “ ” (SET TEMPERATURE)
4
5
DISPLAY “ ” (AIR FLOW FLAP)
Refer to page 9.
6
DISPLAY “ ” “ ” “ ” (FAN SPEED)
The display shows the set fan speed.
7
8
ON/OFF BUTTON
9
FAN SPEED CONTROL BUTTON
M L H
C
12
TIMER MODE START/STOP BUTTON
Refer to page 10.
13
TIMER RESERVE/CANCEL BUTTON
Refer to page 11.
14
Refer to page 9.
15
16
FILTER SIGN RESET BUTTON
17
18
EMERGENCY OPERATION SWITCH
19
RECEIVER
20
21
TIMER INDICATOR LAMP (Green)
This lamp stays lit while the timer is set.
22
23
DEFROST LAMP (Orange)
10
TEMPERATURE SETTING BUTTON
11
DISPLAY “ ” (SIGNAL
TRANSMISSION)
DISPLAY “ ” “ ” “ ” “ ”
“ ” (OPERATION MODE)
This lights up when a signal is being
transmitted.
This display shows the current OPER-
ATION MODE.
This display shows the set tempera-
ture.
This display shows PROGRAMMED
TIME of the system start or stop.
When the INSPECTION/TEST OPER-
ATION BUTTON is pressed, the display
shows the system mode is in.
Do not operate this button during nor-
mal use.
hr. hr.
Press the button and the system will
start. Press the button again and the
system will stop.
Press this button to select the fan
speed, Low or Middle or High, of your
choice.
Use this button for temperature setting
and programming “START and/or
STOP” time. (Operates with the front
cover of the remote controller opened.)
Use this button for SETTING TEMPER-
ATURE.
TEMPERATURE ADJUSTMENT/
PROGRAMMING TIMER BUTTON
AIR FLOW DIRECTION ADJUST
BUTTON
OPERATION MODE SELECTOR
BUTTON
Press this button to select OPERATION
MODE. “ ” (COOL), “ ” (HEAT),
“ ” (AUTO), “ ” (FAN),
“ ” (DRY).
Refer to the section of MAINTENANCE
in the operation manual attached to the
indoor unit.
INSPECTION/TEST OPERATION
BUTTON
OPERATING INDICATOR LAMP
(Red)
AIR FILTER CLEANING TIME
INDICATOR LAMP (Red)
This button is used only by qualified
service persons for maintenance
purposes.
This switch is readily used if the remote
controller does not work.
This receives the signals from the
remote controller.
This lamp stays lit while the air
conditioner runs. It flashes when the
unit is in trouble.
Lights up when it is time to clean the air
filter.
Lights up when the defrosting opera-
tion has started.
DISPLAY “ ”
(PROGRAMMED TIME)
DISPLAY “
TEST
”
(INSPECTION/ TEST OPERATION)