Daikin RP100L7V1, Руководство по установке

Страница: 10 / 18

Installation manual
6
R(Y)P71~W1
Split System air conditioners
4PW14486-1B
Preventing foreign objects from entering
Plug the pipe through-holes with putty or insulating material
(procured locally) to stop up all gaps, as shown in the figure.
Insects or small animals entering the outdoor unit may cause a short
circuit in the electrical box.
Cautions for handling stop valve
■
The stop valves for indoor-outdoor connecting piping are closed
at shipment from the factory.
The names of parts of the stop valve are shown in the figure.
■
Since the side boards may be deformed if only a torque wrench
is used when loosening or tightening flare nuts, always lock the
shut-off valve with a wrench and then use a torque wrench.
Do not place wrenches on the valve lid.
■
For cooling operation under low ambient temperature or any
other operation under low pressure, apply silicon sealing pad,
etc. to prevent the freezing of flare nut gas pipe portion of the
stop valve. Refer to the figure.
How to use the shut-off valve
Use hexagonal wrenches 4 mm and 6 mm.
■
Opening the valve
1. Place the hex wrench on the valve bar and turn counter-
clockwise.
2. Stop when the valve bar no longer turns. It is now open.
■
Closing the valve
1. Place the hex wrench on the valve bar and turn clockwise.
2. Stop when the valve bar no longer turns. It is now closed.
Cautions for handling the valve cover
■
The valve cover is sealed where indicated by the arrow.
Refer to the figure.
Take care not to damage it.
■
After operating the valve, be sure to tighten the valve cover
properly.
Tightening torque:19.6-24.5 N•m
■
Check for refrigerant leakage after tighten the cap.
Cautions for handling service port
■
After the work, tighten the valve cover in place.
Tightening torque: 10.8-14.7 N•m
Precautions when connecting field piping and regarding
insulation
■
Be careful not to let the indoor and outdoor branch piping come
into contact with the compressor terminal cover.
If the liquid-side piping insulation might come into contact with it,
adjust the height as shown in the figure below. Also, make sure
the field piping does not touch the bolts or outer panels of the
compressor.
■
When the outdoor unit is installed above the indoor unit the
following can occur:
The condensated water on the stop valve can move to the
indoor unit. To avoid this, please cover the stop valve with
sealing material.
■
If the temperature is higher than 30°C and the humidity is higher
than RH 80%, then the thickness of the sealing materials should
be at least 20 mm in order to avoid condensation on the surface
of the sealing.
■
Be sure to insulate the liquid and gas-side field piping and the
refrigerant branch kit.
(The highest temperature that the gas-side piping can reach is
around 120°C, so be sure to use insulating material which is
very resistant.)
1 Putty or insulating material
(produced locally)
Make sure to keep the valve open during operation.
1 Service port
2 Shut-off valve
3 Field piping connection
4 Valve cover
Silicon sealing pad
(Make sure there is no gap)
Closing direction
A Liquid side
B Gas side
1
3
4
1
2
A
B
Any exposed piping may cause condensation or burns
if touched.
2
1
3
5
5
A
4
4
6
1 Compressor
2 Terminal cover
3 Indoor and outdoor
field piping
4 Corking, etc.
5 Insulation material
6 Bolts
A Be carefull with pipe,
bolt and outer panel
connections