Introduction
www.DaikinApplied.com
3
IM 1272 • OPTILINE VERTICAL FAN COILS
Introduction
General
CAUTION
Sharp edges and coil surfaces are a potential injury hazard. Avoid contact
with them.
This manual contains the installation and operating instructions
for your an coil system. There are some precautions that
should be taken to derive maximum satisfaction from it.
Improper installation can result in unsatisfactory operation or
dangerous conditions.
Read this manual and any instructions packaged with separate
equipment prior to installation. Give this manual to the owner
and explain its provisions. The owner should retain this manual
for future reference.
Safety Information
NOTICE
The manufacturer’s warranty does not cover any damage or defect to
the air conditioner caused by the attachment or use of any components,
accessories or devices (other than those authorized by the manufacturer)
into, onto, or in conjunction with the air conditioner. you should be aware
that the use of unauthorized components, accessories or devices may
adversely affect the operation of the air conditioner and may also endanger
life and property. The manufacturer disclaims any responsibility for such
loss or injury resulting from the use of such unauthorized components,
accessories or devices.
WARNING
Provide adequate combustion and ventilation air to the unit space as
specified in the combustion and ventilation air section of these instructions.
WARNING
Install this unit only in a location and position as specified in the Mechanical
Installation section of these instructions. Provide adequate combustion and
ventilation air to the unit space as specified in the venting section of these
instructions.
DANGER
Combustion products must be discharged outdoors. Connect this unit to an
approved vent system only, as specified in Mechanical Installation section
of these instructions. Use only with type of gas approved for this unit. Refer
to the unit rating plate.
DANGER
Never test for gas leaks with an open flame. It can cause an explosion or fire
resulting in property damage, personal injury or death. Use a commercially
available soap solution made specifically for the detection of leaks to check
all connections, as specified in the Mechanical Installation section of these
instructions.
WARNING
Always install unit to operate within the unit’s intended temperature-rise
range with a duct system which has an external static pressure within the
allowable range, as specified in the Mechanical Installation section of these
instructions. See also unit rating plate.
WARNING
Units are not design certified to be installed inside the structure. Doing so
can cause inadequate unit performance as well as property damage and
carbon monoxide poisoning resulting in personal injury or death.