Daikin Modular Plate, Инструкция по установке, использованию и техническому обслуживанию

Страница: 29 / 64

29
2A
All installation, assembly, electrical connections to the mains and extraordinary maintenance
must be performed
only by qualified personnel authorised by the Retailer or Manufac-
turer
, in compliance with the regulations in force in the country the equipment is to be used
and the standards on the systems and safety in the workplace.
During installation, the area must be free from people
and objects not used for the assembly.
Before starting, make sure you have all the necessary
equipment.
Use only equipment that is in good condition and un-
damaged.
There are two different types of hook, refer to the assembly instructions for the one in your possession.
Any movement carried out after unpacking must be done with the doors closed.
Do not move the units by pulling on the doors, if present, the uprights or other protruding parts that are
not an integral part of the structure.
Do not step on the units!
Before proceeding with the installation of the machine, it is necessary to prepare the power supplies and
utilities necessary for the correct operation of the system and, if required, consulting in advance with the
Manufacturer's Technical Office.
The machine does not require special environmental conditions for its operation. For a correct instal-
lation it is sufficient to prepare a level support surface, indispensable for the correct operation of the
machine and to guarantee the regular opening of the inspection doors.
The altitude of the installation room must be less than 1,000 meters above sea level (at higher altitudes
the electric motors deliver powers lower than the nominal ones).
The installation in the workplace must be done in such a way that the machine and its equipment are
accessible to allow it to start, stop and carry out maintenance work on the machine.
For the choice of location, in general, care must be taken that an operator can move around the ma-
chine without hindrance. The minimum distance to the nearest wall must in any case be at least equal
to the width of the machine.
Where there are no means of transport to move the machine, its positioning must take into account the
free space required for any repairs. It is of course necessary to plan enough space for regular operation,
as well as for machine maintenance, including all the space for any peripheral equipment.
To operate the machine requires:
- Electrical connections;
- Water connection;
- Air duct connection.
Installation
6