Daikin MCS341-DS1-111, Руководство по установке для специалистов

Страница: 12 / 44

3 | Commissioning
Installer reference guide
12
MCS341-DS1-111
Security gateway
4P529063-1A – 2020.12
3 Commissioning
WARNING
Only qualified persons should conduct commissioning.
CAUTION
Preliminary electrical system checks such as earth continuity, polarity, resistance to
earth and short circuit must be carried out by using a suitable test meter by a
competent person.
3.1 About commissioning the Security gateway setup
After you have verified that the Security gateway components have been installed
and all necessary wiring has been completed, you can start the commissioning of
your Security gateway setup.
In this commissioning phase, you will do the following:
▪ Configure your computer to be able to connect to the Security gateway, see
chapter "To connect to the intelligent Tablet Controller for the first time" in the
intelligent Tablet Controller Installer reference guide.
▪ Configure the LAN settings, see "3.3 To connect to the Security gateway for the
first time" [
4
13] To configure the network settings (local commissioning tool).
▪ Configure the date and time, see "To set up the time zone of the Security
gateway" [
4
20].
▪ Add all attached (Daikin) equipment to the Security gateway web interface, see
"4 To commission the iTM or LC8 controller" [
4
21] to configure the connected
devices quickly (local commissioning tool).
3.2 Minimum requirements for the commissioning
Before you start configuring the Security gateway, complete the following
preparations.
▪ Make sure your computer specs comply with the minimal requirements
mentioned in
"7.5 System requirements" [
4
34].
▪ Contact your network administrator for the following network information for
the Security gateway:
- the desired network name for the Security gateway,
- the static IP address and corresponding subnet mask of the Security gateway,
- the static IP address and corresponding subnet mask of the iTM or LC8
controller,
- the IP address of the default gateway,
- the IP address of the DNS server, and
- the IP address of the alternate DNS (if applicable).
▪ Make sure the power of all connected equipment is turned on.