Daikin FXLQ-M, Инженерные данные

Страница: 18 / 30

EDUS39-600-F7_a Installation
FXLQ-M / FXNQ-M 17
the air, or where volatile liquids such as thinner or gas-
oline are handled.
Operating the unit in such conditions may result in fire.
• Heat exchanger fins are sharp enough to cause cuts.
To avoid injury wear gloves or cover the fins when you are
working around them.
• Refrigerant pipes may be very hot or very cold dur-
ing or immediately after operation.
CAUTION
• While following the instructions in this installation
manual, insulate piping in order to prevent condensa-
tion.
Improper piping insulation may result in water leakage and
property damage.
• Be very careful about product transportation.
Some products use PP bands for packaging. Do not use
any PP bands for a means of transportation. It is danger-
ous.
• Safely dispose of the packing materials.
Packing materials, such as nails and other metal or wooden
parts, may cause stabs or other injuries.
Tear apart and throw away plastic packaging bags so that
children do not play with them. If children play with a plastic
bag which was not torn apart, they face the risk of suffoca-
tion.
• Do not turn off the power immediately after stopping
operation.
Always wait at least five minutes before turning off the
power. Otherwise, water leakage or other problems may
occur.
• Make sure to provide for adequate measures in order
to prevent that the outdoor unit be used as a shelter by
small animals.
Small animals making contact with electrical parts can
cause malfunctions, smoke, or fire. Please instruct the cus-
tomer to keep the area around the unit clean.
NOTE
• Install the indoor and outdoor units, power supply wiring
and connecting wires at least 3.5 ft. away from televi-
sions or radios in order to prevent image interference or
noise.
Depending on the radio waves, a distance of 3.5 ft. may not
be enough to eliminate the noise.
• Remote controller (wireless kit) transmitting distance
is shorter than expected in rooms with electronic fluo-
rescent lamps
• Radio interference may result if installed too close to
other electrical devices. Dismantling of the unit, and
treatment of the refrigerant, oil, and other parts,
should be done in accordance with the relevant local
and national regulations.
2. BEFORE INSTALLATION
• Be sure to read this manual before installing the indoor
unit
• When moving the unit while removing it from the pack-
ing case, be sure to lift it by the four hanger brackets.
Avoid putting any pressure on other parts especially
the refrigerant piping. Be sure to check the type of R-
410A refrigerant to be used before installing the unit as
using an incorrect refrigerant prevents normal opera-
tion of the unit.
• The accessories needed for installation must be retained in
your custody until the installation work is completed. Do not
discard them!
• Decide upon a line of transport.
• Leave the unit inside its packaging while moving until
reaching the installation site. If unpacking is unavoidable,
use a sling of soft material or protective plates together with
a rope when lifting, to avoid damage or scratches to the
unit.
• For the installation of an outdoor unit, refer to the installa-
tion manual attached to the outdoor unit.
• Do not install or operate the unit in rooms where the follow-
ing conditions might exist:
• Laden with mineral oil, or filled with oil vapor or
spray such as in kitchens. Plastic parts may deteri-
orate which could eventually cause the unit to fall
out of place, or could lead to leaks.
• Corrosive gas such as sulfurous gas exists. Copper
tubing and brazed spots may corrode which could
lead to refrigerant leaks.
• Machines generating electromagnetic waves that
can cause the Control System to malfunction.
• Where the air contains high levels of salt such as
near the ocean, and where voltage fluctuates greatly
such as in factories.
Also in vehicles or vessels.
• This unit, both indoor and outdoor, is suitable for installation in
a commercial and light industrial environment.
If installed as a household appliance it could cause electro-
magnetic interference.
WARNING
• Entrust installation to the place of purchase or an autho-
rized serviceman. Improper installation could lead to leaks
and, in worse cases, electric shock of fire.Use of unspeci-
fied parts could lead to the unit falling, leaks and, in worse
cases, electric shock or fire.