23
Care and Cleaning
Take off the titanium apatite
1.
photocatalytic air-purifying
fi
lter.
Open the front panel and pull out the air
fi
lters.
•
Hold the recessed parts of the frame and unhook
•
the 4 claws.
Claw
Claw
Clean or replace the titanium
2.
apatite photocatalytic air-
purifying
fi
lter.
[Maintenance]
Vacuum dust, and soak in lukewarm
2-1
water or water for about 10 to
15 minutes if dirt is heavy.
Do not remove the
fi
lter from frame when washing
•
with water.
After washing, shake off remaining
2-2
water and dry in the shade.
Since the material is made out of polyester, do not
•
wring out the
fi
lter when removing water from it.
[Replacement]
Remove the tabs on the
fi
lter
frame and replace with a new
fi
lter.
Do not throw away the
fi
lter frame. Reuse the
fi
lter
•
frame when replacing the titanium apatite
photocatalytic air-purifying
fi
lter.
Dispose of the old
fi
lter as non-
fl
ammable waste.
•
Set the
fi
lters as they were
3.
and close the front panel.
Press the front panel at both sides and the center.
•
NOTE
Operation with dirty
fi
lters:
•
cannot deodorize the air,
–
cannot clean the air,
–
results in poor heating or cooling,
–
may cause odor.
–
Dispose of old
fi
lters as non-
fl
ammable waste.
•
To order titanium apatite photocatalytic air-purifying
•
fi
lter contact to the service shop there you purchased
the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying
fi
lter (without frame) 1 set
Part No.
KAF970A46
Titanium apatite photocatalytic air-purifying
fi
lter
01_EN_3P253185-1.indd 23
01_EN_3P253185-1.indd 23
9/16/2009 4:05:17 PM
9/16/2009 4:05:17 PM
