23
■
English
Care and Cleaning
Attaching, cleaning and replacing the air supply filter
(Clean once in about 3 months and replace once in about 1 year.)
Cannot be washed with water.
1. Open the front panel to pull out the air fil-
ter and Titanium apatite photocatalytic air-
purifying filter.
(page 19, 20.)
2. Pull out the air supply filter.
3.
•
Remove dust with a vacuum cleaner.
•
The component of the filter is weak in water. Do not rinse the
filter.
Discharge the 4 tabs of the filter frame and
replace the filter with a new one.
•
Dispose a used filter as unburnable waste. (material: polyes-
ter)
4. Replace the air supply filter to its original
position.
5. Set the Titanium apatite photocatalytic air-
purifying filter and the air filter as they
were and close the front panel.
(page 19, 20.)
CAUTION
Cleaning the indoor unit and the remote controller
•
Wipe with a soft dry cloth.
For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound, scrubbing brushes,
nor other hand stuff.
In upward
direction
•
Hold the knob to pull up.
Air supply filter (Yellow)
Cleaning
Replacing
Set the filter with
the tape side down.
Holes
(4 locations)
Tabs
(4 locations)
Filter frame
Filter frame
Air supply filter
•
Do not forget to replace the filter to its original position after cleaning it. Operating the unit in HUMIDIFYING mode without attaching the
filter may cause condensation to form inside the panel or others, causing water to leak.
01_EN_3P190650-1D.fm Page 23 Tuesday, March 6, 2007 6:26 PM