Daikin FTXG25CVMAW, Руководство по обслуживанию

Страница: 55 / 196

Instruction Si04-402A
46 System Configuration
5
■
Outdoor Unit
■ ■ ■ ■
Indoor Unit
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Top front panel
5. Supporting plate:
• The supporting plate is used to support
the front panel during maintenance.
6. Panel tab
7. Flap (horizontal blade): (page 12.)
8. Air outlet
9. Louvers (vertical blades):
• The louvers are inside of the air outlet.
(page 12.)
10. Bottom front panel
11. Display
12. Indoor Unit ON/OFF switch: (page 10.)
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
• This switch is useful when the remote controller
is missing.
13. Room temperature sensor:
• It senses the air temperature around the unit.
14. Operation lamp (green)
15. TIMER lamp (yellow):
(page 18.)
16. INTELLIGENT EYE lamp (green): (page 16.)
17. INTELLIGENT EYE sensor:
• It detects the movements of people and auto-
matically switches between normal operation
and energy saving operation. (page 16.)
18. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed ..........beep
• Operation stop ..............beeeeep
■
■ ■
■
Outdoor Unit
19. Air inlet: (Back and side)
20. Air outlet
21. Refrigerant piping and inter-unit cable
22. Drain hose
23. Earth terminal:
• It is inside of this cover.
Appearance of the outdoor unit may differ from some models.
21
22
23
20
19
Mode
Temperature
setting
Air flow
rate
FTXG AUTO 25
°
C AUTO