![background image](http://html1.mh-extra.com/html/daikin/fhq24mvju/fhq24mvju_operation-manual_4700456007.webp)
8
TEMPERATURE SETTING
Press TEMPERATURE SETTING button and program the
setting temperature.
Each time this button is pressed, setting tempera-
ture rises 1°F.
Each time this button is pressed, setting tempera-
ture lowers 1°F.
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the remote controller is
60°F to 90°F.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The micro computer may sometimes control the fan speed in
order to protect the unit.
AIR FLOW DIRECTION ADJUST
• There are 2 ways of adjusting the air discharge angle.
1. A. Up and down direction
2. B. Left and right direction
A. UP AND DOWN DIRECTION
Press the AIR FLOW DIRECTION ADJUST button to select
the air direction as shown below.
The AIR FLOW FLAP display swings
as shown below and the air flow direc-
tion continuously varies.
(Automatic swing setting)
Press AIR FLOW DIRECTION
ADJUST button to select the air direc-
tion of your choice.
The AIR FLOW FLAP display stops
swinging and the air flow direction is
fixed (Fixed air flow direction setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer controls the air flow
direction so it may be different from the display.
Operation mode includes automatic operation.
Operate in the following order.
• The timer is operated in the following two ways.
• Programming the stop time (
) .... The system stops
operating after the set time has elapsed.
• Programming the start time (
) .... The system starts
operating after the set time has elapsed.
• The timer can be programmed a maximum of 72 hours.
• The start and the stop time can be simultaneously pro-
grammed.
TIMER MODE START/STOP
Press the TIMER MODE START/STOP button several times
and select the mode on the display.
The display flashes.
For setting the timer stop .... “
”
For setting the timer start .... “
”
PROGRAMMING TIME
Press the PROGRAMMING TIME button and set the time for
stopping or starting the system.
When this button is pressed, the time advances by 1
hour.
When this button is pressed, the time goes back-
ward by 1 hour.
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display “
or
” changes from flashing light to a
constant light.
Refer to Fig. 4 on page 3
NOTE
• When setting the timer Stop and Start at the same time,
repeat the above procedure from
to
once again.
When the timer is programmed to stop the system after 3 hours
and start the system after 4 hours, the system will stop after 3
hours and then 1 hour later the system will start.
• After the timer is programmed, the display shows the remain-
ing time.
A. Up and down direction
B. Left and right direction
swing
Operation
mode
Cooling
Heating
Operation
condition
• When operating contin-
uously at downward air
flow direction
• When room tempera-
ture is higher than the
set temperature
• At defrost operation
PROGRAM TIMER OPERATION
1
2
3
1
3
Содержание FHQ24MVJU
Страница 12: ...0510 FS 3PN05140 9W EM04A050A...