Daikin FAA100AUVEB, Руководство по установке, Страница: 11 / 32

English 9
< How to attach the front grille (for 100 class only) >
Attach the screw cover (6) provided with the air outlet. (3 places)
•
Remove the drain plug, the insulation tubing, and the drain hose from the drain pan and replace.
(Refer to Fig. 10)
•
Mold the local refrigerant piping ahead of time, matching it to the liquid pipe and gas pipe marks
engraved on the installation panel (1).
< Replacing the drain hose and drain plug >
(1) Remove the drain plug and insulating tube.
(2) Remove the drain hose installation screws, and pull out the drain hose.
(3) Replace the drain plug and the insulating tube onto the right side.
(4) Replace the drain hose onto the left side, and secure the hose with the installation screws.
If the drain hose is not replaced, water is likely to be accumulated inside the unit. The occurrence of slime may
clog the hose and cause water leakage.
(4)
Hook the indoor unit onto the installation plate. (Refer to Fig. 11)
•
Placing buffering material between the wall and the indoor unit at this time will make work easier.
For right, bottom-right, and back-right piping
•
Pass the drain hose and the refrigerant piping to the wall.
Drain plug
Insulating tube
Fig. 10
Do not place lubricant (refrigerant oil) when inserting.
This may cause deterioration and water leaks.
Insert using a hexagon wrench (4mm).
Make sure
there are
no gaps.
Refrigerant pipe
Be sure to pass all wires through
the wiring guide.
Tab
There are 2 places for 71 class.
There are 3 places for 100 class.
Wiring (locally procured)
Wiring the units, Earth wiring,
Remote controller wiring
Installation plate (1)
(accessory)
Front panel
Front grille
Control box cover
Place buffering material
Hook the indoor unit hook onto the installation plate (1).
Fig. 11
Wall
Drain hose
4PEN468968-1C.book Page 9 Friday, March 24, 2017 1:30 PM