Daikin EHSHB04P30D, Руководство по эксплуатации

Страница: 47 / 532

7 Parameter settings
Operating Instructions
47
Daikin RoCon+ HP
Daikin Controller RoCon+ HP
008.1444299_01 – 09/2018 – EN
INFORMATION
Depending on the device type, the system configuration
and the version of the device software, individual informa-
tion parameters listed in
Chap. 7.7 cannot be displayed or
are displayed at another parameter level.
7.7.3 Water pressure
[→ Main menu → Information → Pressure]
Parameters Setting range
Min / Max
Description Factory
setting
Incre-
ment
Access
BE HF
Water pres-
sure 0 - 4 bar The current water pressure is displayed in bar. - 0.1 bar S S
Tab. 7-30 Parameter in menu: "Water pressure"
7.8 Error
[→ Main menu → Error]
Parameters Setting range
Min / Max
Description Factory
setting
Incre-
ment
Access
BE HF
Emergency
operation Emergency heating by backup heater or another external heat generator. - E E
No Yes: In the event of an error, emergency operation is automatically activ-
ated.
Yes No: In the event of an error, emergency operation by manual activation
only.
Manual oper-
ation status Inactive Activation of the fixed feed temperature control (for diagnostic purposes). - E E
Active
Temperature,
manual oper-
ation 20 - 80 °C Required feed temperature for manual operation. 50 °C - E E
Tab. 7-31 Parameter in menu: "Error"
7.9 Terminal
[→ Main menu → Terminal]
Parameters Setting range
Min / Max
Description Factory
setting
Incre-
ment
Access
BE HF
Terminalad-
ress Off Setting of the terminal ID of the control panel for system access. The set
value must be unique throughout the entire system. Confirmation of this
parameter with the rotary button effects a new initialisation of the control
unit.
All settings except "Off", authorise the user of the control panel to activate
the terminal function and thus to operate all RoCon system components
with a valid device ID.
Off 1 N E
0 - 9
Bus - Scan Off No function Off - E E
On Control unit checks which RoCon devices are connected in the system via
CAN bus lines. Detected devices are displayed in the menu [→ Main menu
→ Terminal] with type and data bus ID (e.g. MM#8 = mixer module with
bus ID 8).
Contr BM1/
BE1 #X With a detected device only: Activation switches to the heat generator with
the bus ID X (see
Chap. 4.8 , [BUS ID HS] parameter).
-
Mix Valve #X With a detected device only: Activation switches to the mixer module with
the bus ID X (see
Chap. 4.8 , [Heating circuit assignment] parameter).
- E E
Tab. 7-32 Parameter in menu: "Terminal"