Daikin DCM601A72, Руководство по установке

Страница: 4 / 36

4 Installation Manual 3P291714-4
DCM601A72 iTM plus adaptor
English
CAUTION
•
Keep water out of the controller.
•
To avoid leakage and electric shock due to entry of water or insects, fill the wir-
ing through-hole with putty.
• Do not wash the controller with water as it may result in electrical shocks or
fire.
•
Do not touch the controller buttons with wet fingers.
Touching the buttons with wet fingers can cause an electric shock.
• Do not install the controller in the following locations:
(a) Where a mineral oil mist or oil spray or vapor is produced, for example, in a
kitchen.
Plastic parts may deteriorate and fall off or result in water leakage.
(b) Where corrosive gas, such as sulfurous acid gas, is produced.
Corroding copper pipes or soldered parts may result in refrigerant leakage.
(c) Near machinery emitting electromagnetic waves.
Electromagnetic waves may disturb the operation of the control system and cause
the unit to malfunction.
(d) Where flammable gas may leak, where there is carbon fiber or ignitable dust
suspensions in the air, or where volatile flammables such as thinner or gaso-
line are handled.
Operating the unit in such conditions can cause a fire.
(e) High temperature area or directly flamed point.
Heating and/or fire can occur.
(f) Moist area, where there is exposure to water.
If water enters the inside of the controller, it may cause electric shock and electrical
components may fail.
NOTE
• Install the control wires for the controller at least 3.5 feet (1 meter) away from
televisions or radios to prevent image interference or noise.
Depending on the radio waves, a distance of 3.5 feet (1 meter) may not be sufficient
to eliminate the noise.
• If water enters inside of the controller, electric shock may be caused and inner
electronics may fail.
01_EN_3P291714-4.indd 4 3/26/2012 5:00:44 PM