Daikin DCM601A51, Технические данные инструкция

Страница: 222 / 405

218
Commissioning Manual ED721208
Commissioning Manual EM11A021
DCM601A51 intelligent Touch Manager
13
Basic Functions
4. Service Settings
4-1 Mgmt. Point Data Regist
Register, modify, and delete management points to be controlled using the iTM. Management points can be
TGIKUVGTGFKPVYQYC[UFKTGEVN[YKVJVJGK6/WPKVQTD[GFKVKPIC%58ƂNGQPC2%CPFNQCFKPIKVVQVJGK6/WPKV
6JGƂIWTGDGNQYUJQYUVJGƃQYEJCTVQHCOCPCIGOGPVRQKPVTGIKUVTCVKQP
Install iTM and equipment
in the site
Install iTM and
equipment in the site
Install iTM and
equipment in the site
Start up iTM and auto
recognize A/C
Start up iTM and auto
recognize A/C
Replace A/C and register
management points
using auto recognition
Start up iTM and auto
recognize A/C
Scope of this chapter
See 4-7 Pre-engineering
Preparation Operation (Control/Check) Operation (Update)
9QTMƃQY
When creating management point data after installing iTM
When installing iTM after creating management point data
When creating management point data using
pre-engineering tool and loading the management
point data to an installed iTM
1WVRWV%58ƂNGYKVJ
management point data
to register management
points other than A/C
'FKVVJG%58ƂNGCPF
create the manage-
ment point data
Merge the created
management point data
KPVJG%58ƂNGYKVJVJCV
on the site’s iTM
Control and monitor
equipment based on
the registered
management point data
Replace or add A/C
and/or equipment,
and output CSV
ƂNGCPFTGIKUVGT
management point
data
Start up the iTM to be
installed in the site and output
C%58ƂNGYKVJQWVCP[
registered management point
'FKVVJG%58ƂNGCPF
create the management
point data
Enter the created
management point data in
VJG%58ƂNGVQVJGK6/VQDG
delivered to the site
Check that the management
point data registered in
advance has no errors
Create management
point data using the
pre-engineering tool
Load the management
point data created using
the pre-engineering tool
to iTM