Daikin DCM601A51, Руководство по вводу в эксплуатацию

Страница: 14 / 125

Commissioning Manual EM11A021
DCM601A51 intelligent Touch Manager
13
Basic Functions
4. Service Settings
4-1 Mgmt. Point Data Regist
Register, modify, and delete management points to be controlled using the iTM. Management points can be
registered in two ways: directly with the iTM unit, or by editing a CSV file on a PC and loading it to the iTM unit.
The figure below shows the flowchart of a management point registration.
Install iTM and equipment
in the site
Install iTM and
equipment in the site
Install iTM and
equipment in the site
Start up iTM and auto
recognize A/C
Start up iTM and auto
recognize A/C
Replace A/C and register
management points
using auto recognition
Start up iTM and auto
recognize A/C
Scope of this chapter
See 4-7 Pre-engineering
Preparation Operation (Control/Check) Operation (Update)
Workflow
When creating management point data after installing iTM
When installing iTM after creating management point data
When creating management point data using pre-engineering tool and loading the management point data to an installed iTM
Output CSV file with
management point data
to register management
points other than A/C
Edit the CSV file and
create the manage-
ment point data
Merge the created
management point data
in the CSV file with that
on the site’s iTM
Control and monitor
equipment based on
the registered
management point data
Replace or add A/C
and/or equipment,
and output CSV
file, and register
management point
data
Start up the iTM to be
installed in the site and output
a CSV file without any
registered management point
Edit the CSV file and
create the management
point data
Enter the created
management point data in
the CSV file to the iTM to be
delivered to the site
Check that the management
point data registered in
advance has no errors
Create management
point data using the
pre-engineering tool
Load the management
point data created using
the pre-engineering tool
to iTM