Daikin BRC7EA628, Руководство по эксплуатации

Страница: 6 / 20

4 English
Do not leave the remote controller
wherever there is a risk of wetting.
If water gets into the remote controller
there is a risk of electrical leakage and
damage to electronic components.
When using the wireless remote con-
troller, do not put a strong light beam or
install an inverter fluorescent lamp near
the receiving section on the main unit.
A malfunction may occur.
Watch your steps at the time of air fil-
ter cleaning or inspection.
High-place work is required, to which
utmost attention must be paid.
If the scaffold is unstable, you may fall or
topple down, thus causing injury.
2. Names and functions of the
operating section (Fig. 1, 2)
1
DISPLAY “ ”
(SIGNAL TRANSMISSION)
This lights up when a signal is being
transmitted.
2
DISPLAY “ ” “ ” “ ” “ ”
“ ” (OPERATION MODE)
This display shows the current OPER-
ATION MODE. For cooling only type,
“
” (Auto) and “ ” (Heating) are
not installed.
3
DISPLAY “ ” (SET TEMPERATURE)
This display shows the set temperature.
4
DISPLAY “ ”
(PROGRAMMED TIME)
This display shows PROGRAMMED
TIME of the system start or stop.
5 DISPLAY “
” (AIR FLOW FLAP)
Refer to page 9.
6 DISPLAY “
” (FAN SPEED)
The display shows the set fan speed.
M H L
C
hr.
hr.
7
DISPLAY “ ”
(INSPECTION/ TEST OPERATION)
When the INSPECTION/TEST OPER-
ATION BUTTON is pressed, the dis-
play shows currently set mode.
8
ON/OFF BUTTON
Press the button and the system will
start. Press the button again and the
system will stop.
9
FAN SPEED CONTROL BUTTON
Press this button to select the fan speed,
HIGH/LOW (BRC7EA628/29) or HIGH/
MEDIUM/LOW (BRC7EA630) of your choice.
10
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEM-
PERATURE (Operates with the front
cover of the remote controller closed.)
11
PROGRAMMING TIMER BUTTON
Use this button for programming
“START and/or STOP” time. (Operates
with the front cover of the remote con-
troller opened.)
12
TIMER MODE START/STOP BUTTON
Refer to page 9.
13
TIMER RESERVE/CANCEL BUTTON
Refer to page 10.
14
AIR FLOW DIRECTION ADJUST BUTTON
Refer to page 8.
15
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERA-
TION MODE.
16
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE
in the operation manual attached to the
indoor unit.
17
INSPECTION/TEST OPERATION
BUTTON
This button is used only by qualified ser-
vice persons for maintenance purposes.
18
EMERGENCY OPERATION SWITCH
This switch is readily used if the remote
controller does not work.
TEST
3PEN505118-2B.book Page 4 Thursday, January 7, 2021 10:28 AM