Remote Controller (Wireless Type)
OH12-01
178
Control Systems
3P107423-1B
7
English
(Example)
If the time to clean air filter is set to “Filter Contamination-Heavy”, set Mode No. to “10”, FIRST CODE NO. to
“0”, and SECOND CODE NO. to “02”.
NOTE
•
The SECOND CODE NO. is factory set to “01”. However, for the following cases it is set to “02”.
•
Air Flow Direction Range Setting
Do not use any settings not listed in the table.
For group control with a wireless remote controller, initial settings for all the indoor units of the group are equal.
(For group control, refer to the installation manual attached to the indoor unit for group control.)
MODE
NO.
FIRST
CODE
NO.
DESCRIPTION OF SETTING
SECOND CODE NO. NOTE)
01
02
03
10
0
Filter Contamination-
Heavy/Light (Setting
for spacing time of dis-
play time to clean air
filter) (Setting for when
filter contamination is
heavy, and spacing
time of display time to
clean air filter is to be
halved)
Long-life
type
light
approx.
2,500
hours
heavy
approx.
1,250
hours
-
3
Spacing time of display time to
clean air filter count
(Setting for when the filter sign is
not to be displayed)
Display
Do not display
-
12
(VRV
system)
1
ON/OFF input from outside (Set to
enable starting/stopping from
remote.)
Forced OFF input
ON/OFF
-
2
Thermostat differential changeover
(Set when using remote controller
thermostat sensor.)
1˚C
0.5˚C
-
13
1
Selection of Air Flow Direction (Set-
ting for when a sealing member of
air discharge outlet kit has been
installed)
F
T
W
4
Air Flow Direction Range Setting
Upper
Normal
Lower
