Daikin BRC4C82, Руководство по установке

Страница: 5 / 7

5
3. Attach the upper part of remote controller.
(Install the upper part on the lower part being careful parts
are facing in the correct direction. After installation, turn on
the power, and test emergency run button.)
NOTE
1. The control box and wiring are not included.
2. Do not directly touch the PC-board with your hand.
4-7. Setting the address of wireless remote controller
(It is factory set to “1”.)
<Setting from the remote controller>
(1) Hold down the “ ” button and the “ ”
button for at least 4 seconds to get the FIELD SET
MODE. (Indicated in the display area in the figure at top.)
(2) Press the “ ” button and select a multiple setting
(A/b). Each time the button is pressed the display
switches between “A” and “b”.
(3) Press the “ ” button and “ ” button to set the
address.
Address can be set from 1 to 6, but set it from 1 to 3 and
to same address as the receiver. (The receiver does
not work with address from 4 to 6.)
(4) Press the “ ” button to enter the setting.
(5) Push the “ ” button to quit the FIELD SET
MODE and return to the normal display.
<Multiple settings A/b>
When the indoor unit is being operating by outside control (cen-
tral remote controller, etc.), it sometimes does not respond to
ON/OFF and temperature setting commands from this remote
controller. Check what setting the customer wants and make the
multiple setting as shown below.
4-8. Stick the Unit No. label on the receiver and the back of
the wireless remote controller.
CAUTION
Set the Unit No. of the receiver and the wireless remote con-
troller to be equal. If the settings differ, the signal from the
remote controller cannot be transmitted.
Upper part
Emergency run button
Upper part
MODE
TIMER
RESERVE CANCEL
DOWN
UP
TEST
FAN
TIME
TEMP
ON OFF
SETTING
Mode
Address
Multiple setting
(3)
(2)
(4)
(1)
(5)
TEST
FAN
Remote controller Indoor unit
Multiple setting Remote control-
ler display To control other
air conditions
and units For other than
on left
A: Standard All items dis-
played. Commands other
than ON/OFF
and temperature
setting accepted.
(1 LONG BEEP
or 3 SHORT
BEEPS emitted)
b: Multi System Operations remain
displayed shortly
after execution All commands accepted.
(2 SHORT BEEPS)
UP DOWN
RESERVE
TEST
1
Unit No. label (5)
Wireless remote
controller (2)