SMLC-213-154
17
4.3.5 Setting mode
Various kinds of setting are performed. Setting mode is three types, and operations are different.
DISPLAY is pushed in case it returns to the original measurement display. And, if a switch is not operated
for 10 minute after a set point check, it will return to the original measurement display automatically.
Operation and the contents of setting (detail) in setting mode, please refer to "5 Setting".
・Setting mode 1：Press SET for longer than 3 seconds.
・Setting mode 2：Press SET and RESET/SHIFT together for longer than 3 seconds.
・Setting mode 3：Press SET and DISPLAY together for longer than 3 seconds.
<Reference> This operation can perform the maximum, the minimum display, and a ground fault phase detection
display besides an instantaneous measurement display.
SET and RESET/SHIFT 3 seconds
Setting mode 2
Setting No.
Setting mode 1
New setting
Current setting
Setting No.
Maximum zero-phase voltage display
Instantaneous measurement
display
Setting mode 3
SET 3 seconds
SET and DISPLAY 3 seconds
New setting
Current setting
Setting
factor
V(RS)
display
V(ST)
display
V(TR)
display
New setting
Current setting
Setting No.
DISPLAY or 10
minute no operation.
Return to
measurement display.
