Daihen OTC ARXIS pulse P403L, Руководство пользователя

Страница: 137 / 188

W
ELDING
R
ESULT
C
ONTROL
F
UNCTION
A
DMINISTRATOR
F
UNCTIONS
C
HAPTER
7
135
Chapter 7 Administrator F
unctions
T I P S
• After the password is set, if the KEY LOCK is turned ON in the MENU screen, the key mark
will be displayed in the Home screen, and the erroneous operation prevention function
becomes enabled. To disable the erroneous operation prevention function, the password will
be requested.
7.3 Welding Result Control Function
This section explains about the welding result control function. The function enables the management of the items below.
Details of control contents ( 7.3.2
-
Details of welding control items)
Welding control
parameter
Initial vaule Setting range Explanation
Number of welds
0
−
Cumulative number of welding points (number of welds)
0 0 to 999 Target value of welding points (number of welds)
×
 /×
Operation at the time when the target value of welding points is achieved
Total wire consumption
00.0
−
Cumulative wire consumption used in welding (kg)
0 0 to 999 Target wire consumption (kg)
×
 /×
Operation at the time when the target wire consumption is achieved
Total welding time
00:00
−
Cumulative total welding time (hr / min)
00:00
00:00 to 16:39 Target total welding time (hr / min)
×

/× Operation at the time when the target total welding time is achieved
Total operation time
00:00
−
Cumulative total operation time (hr / min)
Maximum fluctuation
0
−
Max. fluctuation value of average range monitor (A or V)
0 0 ~ 100
Current tolerance ( ＋ ) (%)
0 0 ~ 100 Current tolerance (-) (%)
0 0 ~ 100
Voltage tolerance (
＋
) (%)
0 0 ~ 100 Voltage tolerance (-) (%)
0 0 ~ 100
ERROR judgment time (sec)