DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
DAIHAN Scientific, Steam Sterilizers Digital Fuzzy-controlled Autoclaves .
8/53
2. Installation
2.1 Product Installation
* Caution of Installation
1.
Please be careful when transporting the product because it is heavy.
2.
Please do not lay the product on the floor or subject it to shock. It can cause damage inside
the product.
3.
Please install the product in a hard, flat, and stable place.
4.
Please do not install the product in a place where it is exposed to direct sunlight, or in the
dangerous places.
5.
To minimize the risk of short circuits, do not install the product (in the) places where it will
be subjected to the inflow of moisture or organic solvents on the regulator part or inside of
the body.
6.
This product was manufactured for normal operation at a rated voltage, so please check the
voltage status before installing the product.
7.
When installing and using the product, please certainly use the power cord provided with
the products.
* Installation Process
1.
After receiving the unit and putting it on the specified place of use remove the wrapping.
2.
After positioning the unit, lock the moving wheel in order to make position fixed and the
unit stable.
3.
Check the unit whether there are eventual transport damages or not. In case there are
some transport damages found please inform the forwarder and your contractor. If there is
no damage, please go to next point 3.
4.
Let the unit stand for a few minutes so that the all the internal parts and components of the
unit can be stabilized.
5.
Open the door at the left side of the unit. You can find a room for pipe assembly and
electric distribution plane. Please check carefully if there is anything wrong including
disconnection of the electric wire, breakage of pipe or fitting element. In case there is any
kind of damage found, please inform the forwarder and your contractor. If you cannot find
anything wrong, please go to next point 5.
6.
For normal use of the unit, confirm that the valve is open, and water drain valve is closed.
7.
Connect the main power cord to the socket.
8.
(NOTE)
If you bye MaXterile
TM
80R or MaXterile
TM
100R, power consumption of the heater
in the vessel is too high to use normal wall socket. (Typical wall socket in EU and Asian
countries permits around 3kW maximum per socket) So, a big 3-pole plug (for single-phase
230V AC with ground) comes with power cord, and a socket with wiring connector is
supplied together as seen in the picture on the page 10. You have to wire the power supply
line of enough electric power (4kW for MaXterile
TM
80R and 5kW for MaXterile
TM
100R at
least) to the supplied connector before plugging.
9.
If such a big power supply line is not available in the room where the unit is installed, you
have to contact the appropriate person who is in charge of electric facilities in your
company or organization.
2
2
