DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
DAIHAN Scientific, Digital Hotplates & Stirrers
17/44
Indicate Heating
Operation
the setting value of stirring speed is entered to above 80 RPM in the situation that the agitation
is stopped, it displays the standby state while flashing the STIRRING indication.
-
The POWER rod bar of the Display represents the stirring power, and it is displayed at all times
during the stirring operation. The stirring power is automatically controlled to match the setting
RPM according to the viscosity of the sample.
②
MODE - Set Heating Mode (MSH / MP Model)
-
If pressing once the MODE button in the Set Stirring Mode, it is switched to the temperature
setting mode.
-
The setting temperature is entered by turning the Jog-Dial Knob to clockwise or counter-
clockwise. If the setting value is entered to above 0 , the operation standby state is
℃
displayed while blinking the HEATING indication of LCD Display.
-
The maximum heating temperature is 380
℃
. The Start/Stop of the operation is performed by
the Push button of Jog-Dial Knob.
-
The HEATING indication of LCD Display is always displayed during the operation of HEATING,
and if the setting value is entered to above 0 in the condition that the heating is stopped, the
℃
HEATING indication indicates the standby status while blinking in long interval.
-
In the case of HEATING LED, while the temperature rises by the operation of Heater, the LED
blinks, and when the setting temperature and actual temperature are the same, the Heater
maintains the temperature and the LED is turned off.
-
If the PUSH button of Jog Dial Knob is pressed and held for 2-3 seconds, the setting value is
saved and this saved value is maintained even when the power is turned on again.
* SUB - Set offset value
Temperature compensation is the function that can add or reduce the constant value by setting the
< Fig 3.3.2 > Set Heating Mode
HEATING
150.5
℃
100.10
℃
HEATING LED (Red)
HEATING STIRRING TIMER
Set Temp.
Present Temp.