Dahua Network Camera Web 3.0, Руководство по эксплуатации

Страница: 104 / 144

Dahua Network Camera Web 3.0 Operation Manual
96
Parameter Function
Face
Enhancement
Select “Enable Face Enhancement” and it will guarantee that the face is
clear by priority when the stream is set very low.
Record
Check it and so when alarm occurs, system will auto record.
Note
It also needs to satisfy following two conditions for system record.
 It has enabled motion detect record; refer to 5.4.1.1 Record Schedule
for more details.
 It has enabled auto record; refer to 5.4.3 Record Control for more
details.
Record Delay System can delay the record for specified time after alarm ended.
Relay out Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended.
Send Email
If you enabled this function, System can send out email to alert you when
alarm occurs and ends. User can set email address in Network>SMTP.
Snapshot
Select “Snapshot” and the system will auto trigger alarm and snapshot when
alarm occurs.
Note
It also needs to satisfy following two conditions for system record.

It has enabled motion detect snapshot; refer to 5.4.1.1 Record
Schedule for more details.
 Please refer to 5.4.2.1 Path for searching and setting snap storage
location.
Snap Face
Image
It is to set the range of cutting face image, including human face, one-inch
picture, half body and full body.
Attribute
Click
‘Attribute”, click
to set the attribute display during face detection.
Enable Face
Exposure
Select
“Enable Face Exposure”, it is to make human face much clearer via
adjusting iris, shutter and so on.
Face Target
Brightness
It is to set the brightness of face target, it is 50 by default.
Face Exposure
Detection
Interval
It is to set the face exposure detection interval, it is to prevent image
flickering caused by continuous exposure adjustment, it is 5s by default.
Step 5
Click
“Save” to complete config.
5.3.5.2 Face Database Config