Dahua IPC-HFW2100N Series, Быстрый старт

Страница: 54 / 94

21
IP Version It is to select IP version. IPV4 or IPV6.
You can access the IP address of these two version.
IP Address Please use the keyboard to input the corresponding number to
modify the IP address and then set the corresponding subnet
mask and the default gateway.
Preferred DNS DNS IP address.
Alternate DNS Alternate DNS IP address.
Enable
ARP/Ping set
device IP
address service. You can use ARP/Ping command to modify or set the device IP
address if you know the device MAC address.
Before the operation, please make sure the IPC and the PC in
the same LAN. This function is on by default.
You can refer to the steps listed below.
Step 1 : Get an IP address. Set the IPC and the PC in the same
LAN.
Step 2 : Get the physical address from the label of the IPC.
Step 3 : Go to the Run interface and then input the following
commands.
arp –s <IP Address> <MAC>
ping –l 480 –t <IP Address>
Such as
˖
arp
Ͳ
s 192.168.0.125 11
Ͳ
40
Ͳ
8c
Ͳ
18
Ͳ
10
Ͳ
11
ping
Ͳ
l 480
Ͳ
t 192.168.0.125
Step 4 : Reboot the device.
Step 5 : You can see the setup is OK if you can see there are
output information such as “
Reply from 192.168.0.125 …
” from
the command output lines. Now you can close the command
line.
Step 6 : Open the browse and then input
http://<IP addres>
.
Click the Enter button, you can access now.
4.2.2 Connection
The connection interface is shown as in Figure 4-8.