8
4.
Pre-drill the three (3) perimeter holes for the expansion bolts, using a drill bit that is no wider than
the expansion bolt, according to the position on the mounting template.
5.
Insert an expansion bolt into each pre-drilled perimeter hole.
6.
Determine the route of the cables exiting the camera:
7.
Drill the Cable Outlet hole to route the cable from the camera through the installation medium.
8.
Align the TOP of the camera body with the TOP of the mounting template.
9.
Route the cables from the camera through the installation medium or through the side exit port.
10. Attach the waterproof network connector if the camera is used outdoors.
Figure 4-2
a. Place the wide side of the rubber ring onto the end of the network cable extending out
from the camera.
b. Pull the waterproof cable end without the Ethernet connector through the body of the
Waterproof Connector. Thread the cable through the Fixing Rubber Ring and the
Waterproof Locking Cover.
c. Attach the male Ethernet connector to the network cable coming from the camera.
Ensure the Waterproof Connector shroud covers the Ethernet connection.
d. Connect the other end of the waterproof connector to the network port and rotate it
clockwise to lock the network port and waterproof connector firmly.
e. Slide the Waterproof Locking Cover over the main body of waterproof connector and
rotate it clockwise to seal the connection.
11. Align the three (3) holes on the camera body with the expansion bolts.
12. Insert a self-tapping screw into each hole on the camera body and then into an expansion bolt.
Secure the body to the medium with a Philips-head screwdriver.
13. Connect the Ethernet cable to the Ethernet port and connect the power cable to a 12 VDC power
supply.