User's Manual
11
Parameter
Description
Delay Time
Set the delay time of the flashlight to make sure that the
camera captures and the flashlight flashes at the same time.
Burst Mode
The triggering electrical level (high level and low level) of the
flashlight. Only low electrical level triggering is supported at
present.
Strobe
Output
Mode
Forbidden: Strobe stays off.
Always: Strobe stays on.
Default: Configure the preset value of brightness. When the
environment brightness is lower than the prevalue, the
strobe lights up automatically.
Delay Time
Set the delay time of the strobe to make sure that the camera
captures and the strobe flashes at the same time.
Pulse Width
Set the pulse width value of the strobe. The bigger the value,
the brighter the strobe. When the pulse width is bigger than
the camera shutter, the actual image will not become
brighter.
Frequency
Set the frequency of the strobe flashes.
Step 3
Click
Confirm
.
If the pulse width of the camera is configured as 0, the Illuminator is off.
5.2 Configuring External RS-485 (Strobe)
Plug the RS-485 signal cable of the Illuminator into the A1, B1 port of the camera.
Step 1
Select
Setup
>
ITC
>
Extra Device
>
Light (485) Config
.
Step 2
Select
Strobe
from
COM1
.
Step 3
Configure parameters.
Figure 5-2 Configure strobe parameters
