Quick Start Guide
5
Other Notes:
Special temperature range: T5/T100°C: –40 °C≤ Tamb≤ +60 °C, T6/T80°C: –40 °C≤ Tamb≤ +55 °C.
You can use a soft damp cloth to wipe the body of the device. While using the device, do not
touch metal objects to prevent electrostatic discharge.
●
The Camera is delivered with an eight-meter control cable. The external wiring of the Camera
should be carried out with the device that meets explosion-proof requirements or under safe
area environment. The wire diameter size for external wiring allowed for 8.5mm (Do not replace
the cable randomly. Confirm with the manufacturer if you do need to replace it).
●
Tightening torque of the compression component≥25.5 Nm
●
Yield strength of fastening bolt: > 450 MPa.
●
Make sure that all the explosion-proof components are complete without any cracks and
defects.
●
Install the Camera in a stable place that does not shake and does not have shock vibrations or
insulation-break vapor. Securely install the Camera to make sure that it remains still and does
not move in either direction.
●
Do not touch the heat dissipation components of the Camera to avoid getting burnt.
●
Do not disassemble the Camera unprofessionally. Otherwise, it might cause water leakage or
bad image. If you find that the lens is foggy or the desiccant turns green after disassembling the
device, contact the after-sales service to replace the desiccant. (Some model may not have the
desiccant particles, and the actual conditions shall prevail.)
●
It is recommended to use the Lightening Protector for better lightning-proof effect.
●
Do not touch the image sensor (CMOS) directly. Dust and dirt could be removed with soft cloth
that is moistened with alcohol.
●
Clean the device body with soft dry cloth, and for stubborn stains, use the cloth with mild
detergent. To avoid possible damage on device body coating which could cause performance to
decrease, do not use volatile solvent such as alcohol, benzene, diluent and so on to clean the
device body, nor can strong, abrasive detergent be used.
●
Dome cover is an optical component. Do not touch or wipe the cover with your hands directly
during installation or operation. To remove dust, grease or fingerprints, wipe gently with oil-free
cotton moistened with diethyl or moistened soft cloth. You can also remove dust with an air
blower.
●
Use a wet cloth to clean the transparent cover. The transparent cover has a potential
electrostatic charge hazard.
●
Strengthen the protection of network, device data and personal information by adopting
measures which include but not limited to using strong password, changing password regularly,
upgrading firmware to the latest version, and isolating computer network. For some devices
with old firmware versions, the ONVIF password will not be changed automatically along with
the change of the system password, and you need to upgrade the firmware or manually update
the ONVIF password. Updating firmware will optimize the functions of the Camera without
consuming more power.
●
Use standard components or accessories provided by manufacturer and make sure that the
device is installed and maintained by professional engineers.
