Camera Installation
8
Preparing the Camera
The Network PTZ camera comes with the PFB306W Wall Mount, the installer must supply the
following hardware:
Four (4) bolts, washers or other fastening hardware to secure the wall mount to the
installation medium. The hardware must be capable of supporting eight (8) times the
weight of the camera and mount.
Appropriate tools to mount the camera to the wall.
3.1.1 Unpacking the Camera
Remove the camera, the mount accessories and any hardware packages from the boxes.
Remove the camera from the plastic wrapping and place the camera dome-end up in the
foam packaging.
3.1.2 Insert a Micro SD Card
The Micro SD card slot is located on the ISP board above the camera module
Figure 3-2: Micro SD Card Installation
Loosen the two (2) screws from the rear panel on the back of the dome. Remove the
panel.
Place the Micro SD card with the metal contact down into the slot on the ISP board.
Replace the rear panel.
