DAHAO 41 Series, Руководство пользователя, Страница: 245 / 268

board;
3
、
Check whether the nose transfer plate is short circuit with the nose during
installation.
E-010 Fan or electromagnet failure
1.Turn off the power and unplug the external electromagnet.
2.If no more errors are reported, please check whether the external
electromagnet is damaged.
3.Error still reported after troubleshooting the external fault, please replace the
electric control.
E-011 Stepper motor over speed
If closed loop motor, please check:
1
、
Check whether the motor encoder is damaged;
2
、
Check whether the encoder cable is damaged.
E-012 Stepper motor out of tolerance
If closed loop motor, please check:
1
、
Check whether the motor encoder is damaged;
2
、
Check whether the encoder cable is damaged.
E-013
Spindle encoder is
malfunctioning or not
connected
Turn off the power and check whether the spindle encoder is connected
properly.
E-014 Spindle motor runs abnormally
1.Turn off the power to check whether the machine is stuck, to ensure that the
machine can run smoothly without dead spots.
2.Replace spindle motor.
3.Replace the electric control box.
E-015 Exceeds sewing area Check if the pattern is out of the range of the panel Settings
E-016
Please turn the code plate
position of spindle motor
Turn the hand wheel to lift the needle bar to the upper position of the upper
dead point, and then step the pedal.
E-017
Disconnection detection
anomaly
1.Check whether the position of broken wire detection equipment is correct;
2.Check whether the cable is normally connected;
3.Appropriately increase the number of broken wire detection needles;
4.If still not solved, you can choose to turn off the broken line detection
function or replace the electric control;
E-018 Trimmer position abnormal Please turn off power.
E-019
Emergency switch is not at the
right position
1.Check whether the emergency stop switch is pressed;
2.Check whether the emergency stop switch cable is in good contact;
3.If there is no problem with the switch cable, please replace the electric
control.
Note: If the emergency stop switch is pressed and returns to normal, please
change the type of emergency stop switch.
E-020 Error reading E2PROM
E-021 Error writing E2PROM
E-023
Abnormal position of grabber
line
Please turn off the power.
E-024
Wrong connection between
operation head and sewing
Please turn off power.