DNPB328 Operation Manual
c) Use a spanner to loosen the
connect sleeve (#3)
from the
spring house (#5)
, take out the
mandrel (#1)
,
transfer bar washer (#63)
,
connect sleeve (#3)
,
transfer bar (#4)
and
spring
(#6)
:
d) Take the transfer
bar washer (#63)
out and insert the required
mandrel (#1)
from the tool
accessories pack as per rivnut size, then mount into the
connect sleeve (#3),
transfer bar
(#4),
together with
spring (#6)
install into the
spring house (#5).
Screw the
connect sleeve
(#3
) tight with
spring house (#5)
using a spanner:
e)
Screw the
knurled cover (#12)
and
nose pedestal (#10)
back to the tool, then replace the
locknut (#65),
and
anvil (#2):
MANDREL PROTRUDING SET FOR BLIND NUT
1) Adjust the length of the
mandrel (#1)
that protrudes from the
anvil (#2)
according to the length
of the rivnut to be set by adjusting the position of the
locknut (#65)
, and
anvil (#2)
screwed
on the
mandrel (#1)
:
2) Never set the mandrel protruding length too long or too short for the rivnut to be set:
All manuals and user guides at all-guides.com