29
5. Error Display
MESSAGE
ERROR
CAUSE
SOLUTION
IE
WATER INLET
ERROR
Fail to reach specifying the level
of the water for 30 minutes on
supply water.
- Open the water tap.
- Clean the filter of the valve inlet.
- Change the valve inlet.
- Change the PCB ASS’Y.
- Change the drain motor.
- Change the water level sensor
(sensor pressure).
Not change the level of water
on supply water.
OE
DRAIN
ERROR
After 10 min on supply water.
not reach reset point.
- Clean and straighten the drain hose.
- Change the drain motor.
- Change the valve inlet
- Change the PCB ASS’Y.
- Change the water level sensor.
UE
UN-BALANCE
ERROR
After balance spin 40 times.
don’t operate main spin
- Rearrange the laundry.
If balance spin is fail, don't
operate the rinse.
So don't display 'UE'
- Rearrange the laundry.
LE
DOOR OPEN
ERROR
The Start/Hold button is
pressed while the door is
opened.
- Close the door.
- Change the switch door lock.
E1
Water level
detection error
Water level is below reset or
overflow is detected
Change the sensor pressure.
E2
OVER FLOW
ERROR
The water is supplied
continuously. Then it happens 2
times to over the level of
overflow.
- Change the valve inlet.
- Change the water level sensor
(sensor pressure).
- Change the drain motor.
E3
FAN MOTOR
ERROR
don't receive the HALL IC
signal from the fan motor.
- Change the fan motor.
- Check the connector or change the
PCB ASS’Y .
E9
SENSOR
PRESSURE
ERROR
The water level sensor is
abnomal on less 19KHz , more
28KHz.
- Change the water level sensor.
WFW0A1*,WFW0A2*,WFC0A2*(SM).indd 29
16. 5. 24. 오후 3:20
