Daewoo Mega 250-V, Руководство по эксплуатации и техническому обслуживанию

Страница: 121 / 212

K1000896E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-11
1. Check level of engine oil every day before
starting engine.
2. Remove engine oil dipstick (1, Figure 5).
Oil level must be between "LOW" and
"FULL" marks.
NOTE: If oil is above "HIGH" mark on
dipstick, some must be drained
to return oil to proper level.
3. To add oil, remove engine oil fill cap (2,
Figure 5).
CHECK TRANSMISSION OIL LEVEL SIGHT
GAUGE
1. Use two people to perform this operation.
2. Start machine and drive it until
transmission fluid has warmed to between
82°C (180°F) and 93°C (200°F). Park
machine on firm, level ground. Lower
bucket to ground.
3. Place transmission lever in "NEUTRAL."
Apply parking brake. Shut down engine.
4. Block tires. Once tires are blocked, start
engine and have a person remain in the
cab.
5. With engine running, have second person,
find transmission oil level sight gauge (1,
Figure 9) on transmission fill tube (2).
6. Oil level must be at "HOT" mark or above
as shown in (Figure 9).
NOTE: If oil level is above top end of
sight gauge (completely filling
it), drain oil until level is at
"HOT" mark.
NOTE: If transmission cannot reach an
operating temperature of 80°C
(176°F), then the oil level must
be visible in the sight gauge
below the "HOT" mark.
Periodically check oil level
during the workday to ensure
that oil level does not rise
above top end of sight gauge.
HAOC280L
Figure 7
Figure 8 TRANSMISSION OIL FILL CAP
2
1
BZO0031L
HOT
Figure 9
1. TRANSMISSION SIGHT GAUGE
2. TRANSMISSION FILL TUBE