Fitting a new plug
If for any reason you need to fit a new plug, the flexible mains lead must be
connected as shown below. The wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
Brown wire = Live (L)
Blue wire = Neutral (N)
Green & Yellow = Earth (E)
If colours of the wires in the mains lead of this appliance do not correspond with the
coloured marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured Blue must be connected to the terminal which is marked
with the letter N or coloured Black. The wire which is coloured Brown must be
connected to the terminal which is marked with the letter L or coloured Red. The
wire which is coloured Green & Yellow must be connected to the terminal which is
marked with the letter E or coloured Green.
Before refitting the plug cover check that there are no cut or stray strands of wire
inside the plug. Use a 13 Amp BS 1362 fuse, only BSI or ASTA approved fuses
should be used. If you are in any way unsure which plug or fuse to use, always
refer to a qualified electrician.
Note: After replacing or changing a fuse on a moulded plug which has a fuse cover,
the cover must be refitted to the plug, the appliance must not be used without a
fuse cover.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer for recycling
advic
Europasonic (UK) Ltd
Manchester M3 1JS
www.europasonic.com
Connect Green
& Yellow to
Earth (E)
Connect
Brown to
Live (L)
Connect
Blue to
Neutral (N)
Ensure the outer sheath of the
mains lead is securely held by the
cable clamp
Daewoo Electricals is a registered
trademark.
Produced and imported under
licence by Europasonic (UK) Ltd
