Daewoo Espero, Руководство пользователя

Страница: 78 / 114

COOLANT LEVEL
The cooling system is filled with a glycol
base coolant.
In the correct concentration
the coolant
provides excellent corrosion and freeze
protection for the entire cooling and heat-
ing system and must therefore not be re-
placed by plain water even in summer.
The coolant level should be full in the ra-
diator and slightly above the "COLD" mark
on the coolant surge tank when the engine
is cool. The level rises with the engine at
operating temperature
and drops again
when the engine cools down.
If the level falls below the "COLD" mark,
add enough 50/50 water and ethylene gly-
col anti-freeze mix, to provide freezing and
corrosion protection, to bring the level to
a little over the "COLD" mark.
Change of coolant
Service interval
Capacity
1.5 DOHC: 6.1l
Every
( anti-freeze:
3.0l )
30,000 miles water:
3.1 l
or 3 years
1.8/2.0 MPFI: 8.0l
( anti-freeze: 4.0l )
water:
4.0l
Coolant surge tank
1.5/1.8/2.0 MPI
CAUTION
Do not OVERFILL. If frequent addi-
tions are required, see your Outlet for
a cooling system check.
Do not remove the coolant surge tank
cap when the engine and radiator are
hot.
Scalding hot coolant and steam may be
blown out under pressure, which could
cause serious injury.
WARNING
Do not allow anti-freeze to make con-
tact with the skin or eyes. If this should
happen rinse the affected areas imme-
diately with plenty of water, and con-
sult
a
doctor if any irritation occurs.
8-6
AIR CLEANER
If the vehicle is operated in very dusty or
sandy areas, replace the air cleaner
element more frequently than the usual
recommended intervals.
If it is dirty, shake the element to remove
dust.
Clean the inside of the air cleaner housing
and the cover with a damp cloth.
The air cleaner element can be cleaned
by blowing compressed air through it in
the opposite direction to normal air flow.
Do not operate the vehicle with the air
cleaner element removed.
",
.,
~~
C!..
~lrl ~
~
~ CAUTION
I
I
Do not remove the air cleaner element
unless temporary removal is necessary
during repair or maintenance
of the
vehicle.