20
HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
• Clean the filter when water leaks from the water inlet.
Cleaning the drain filter
• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be
caused.
CAUTION : Be careful when draining if the water is hot.
Cleaning the detergent case
*After a while detergent and fabric softeners leave a deposit in the case;
- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards
and by pulling it out.
- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
*Detergent can also accumulate inside the recess which should be
cleaned occasionally with a brush.
*Once you have finished cleaning, replace the case and run a rinse
cycle without laundry.
1
Pull the power
plug out before
cleaning it.
2
Turn off the water
supply to the
washer and
separate the inlet
hose.
3
Pull the inlet filter
out.
4
Remove the dirt
from the inlet filter
with a brush.
1. Open the lower cover(
1
) by
using a coin. Remove the cap
hose(
2
) to pull out the hose.
2. Unplug the cap hose(
2
), allowing
the water to flow out. At this time
use a vessel to prevent water
flowing on to the floor. When water
does not flow any more, turn the
pump filter(
3
) open to the left.
3. Remove any foreign material
from the pump filter(
3
). After
cleaning, turn the pump filter
clockwise and insert the cap
hose(
2
) to the original place.
Close the lower cover.
1
100
2
3
2
3
