Daewoo DSB-F0969GLH-V, Инструкция по использованию и уходу, Страница: 29 / 41

27
INSTALLATION MANUAL---Installation of the Indoor unit
1 . Decide where to drill the hole in the wall for the pip -
5 mm
Indoors
Outdoors
5. Check that the mounting plate is correctly fixed; Note : The shape of the mounting plate may be different
from the one above, but installation method is similar .
Drilling a hole in the wall for the piping
ing ( if necessary ) according to the position of the
mounting plate;
2. Install a flexible flange through the hole in the wall to
keep the latter intact and clean.
The hole must slope downwards towards the exterior
Note : Keep the drain pipe down towards the direction
of the wall hole, otherwise leakage may occur.
Electrical connections---Indoor unit
1. Lift the front panel.
2. Take off the cover as indicated in the piciure ( by removing a
screw or by breaking the hooks).
3. For the electrical connections, see the circuit diagram on the right part
of the unit under the front panel.
4. Connect the cable wires to the screw terminals by following the
numbering ,Use wire size suitable to the electric power input (see
name plate on the unit) and according to all current national
safety code requirements.
5. The cable connecting the outdoor and indoor units must be suitable
for outdoor use.
6. The plug must be accessible also after the appliance has been
installed so that it can be pulled out if nece ssary.
7. An efficient earth connection must be ensured.
8. If the power cable is damaged, it must be replaced by an authorised
Service Centre.
Note:The cable wires has been connected to the main
PCB of indoor unit by manufacturer according to the
model without terminal block
Refrigerant piping connection
Connecting the pipes
Front panel
Terminal block cover
wiring diagram