Daewoo 2594ST, Инструкция по эксплуатации

Страница: 5 / 13

4
Plug the mains cable into the power socket with 220~240V 50Hz AC.
Additional Information for the set sold in Great Britain
The appliance is supplied with a moulded three pin mains plug fitted with a 5 Amp fuse. Should
the fuse require replacement, it must be replaced with a fuse rated at 5 Amp and approved by
ASTA or BSI to BS1362.
The plug contains a removable fuse cover that must be refitted when the fuse is replaced. In the
event of the fuse cover being lost or damaged, the plug must not be used until a replacement not
be used until a replacement cover has been obtained. Replacement fuse covers can be pur-
chased from your nearest electrical dealer and must be the same colour as the original.
If the moulded mains plug is unsuitable for the socket outlet in your home or is removed for any
other reason. Then the fuse should be removed and the cut off plug disposed of safely to prevent
the hazard of electric shock.
There is a danger of electric shock if the cut off plug is inserted into any socket outlet.
If a replacement plug is to be fitted, please observe the wiring code shown below. The wires in
the mains lead are coloured in accordance with the following code.:
Blue - Neutral, Brown - Live
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter
L or coloured red.
Do not make any connection to the terminal in the plug which is marked by the letter E or by the
safety earth symbol or coloured green or green and yellow.
MAINS CONNECTION
Switching On
Switch the set on with the MAIN POWER button, (
). The set will turn on.
If not, press either : - PR UP or DOWN button on the front of set - or POWER button or the
UP/DOWN button or one of the NUMBER button 0..9 on the remote controller.
The STAND-BY INDICATOR will turn off and a picture will appear on the screen.
Switching off
Press POWER button (
) on the remote controller to return the set to its stand-by mode.
The STAND-BY INDICATOR will illuminate.
If you don't use the set for extended period of time, turn it off with MAIN POWER button
.
SWITCHING THE SET ON AND OFF