DAELIM Roadwin 250R FI VJF125, Руководство по обслуживанию

Страница: 10 / 288

1-7
GENERAL INFORMATION
•
Wire band must be secured firmly in the specified
location of the frame. In case of aluminium band,
secure the wire harness to the coated part.
•
Secure the wire harness firmly using the clamp.
•
Insert the connector until the vinyl cover is fully
inserted into the terminal.
•
The opening of the vinyl cover must face at the ground
direction but in case of the plain connector, the draining
opening must face at the sky direction.
•
When removing T-start, broaden the groove of T-start
using the wiring driver and release the torque.
•
Connect the harness and the hose to T-start and then
insert until the groove is locked.
•
When removing T-start from the frame, replace it with
the new one.
•
In case of the weld clamp, do not clamp in the welded
part.
•
When clamping the wire harness, make sure that the
harness is not contacted with the shaft or rotating part.
•
When clamping the wire, pay attention not to contact
with hot part.
•
The wire harness must be routed without contacting
with the end of the lamp or any sharp edge.
•
The wire harness must be routed without contacting
with the end of the bolt or the piece.
WIRING DRIVER
DRAINING HOLE
GROOVE SIDE