Dacor Wall Oven, Руководство по установке

Страница: 8 / 12

Mounting the Oven
Lift the wall oven up to the cabinet cutout, using
the upper edge of the cavity opening as gripping
points. Use extreme caution when lifting the
appliance as it is heavy. Be certain to take all
necessary safety precautions.
Resting the oven on the cabinet-mounting
platform, slide the oven into the recessed area
(approx. 9”). Support oven at all times. After
handle removal, continue to slide oven until the
back of the trimposts are flush with cabinets and
the oven is centered within the cutout. Ensure
that the electrical conduit slides through the
opening in the cabinet platform or coils above
the oven chassis as the oven is slid into place.
The cable must be placed coiled above the
oven chassis. Do not trap the appliance conduit
between the oven case back and the rear wall.
Locate the mounting holes found in the front
and sides of the trimposts. Using a 1/16” drill,
drill four (single models only) or six (double
models only) pilot holes for the #6 x 3/4” screws
provided in the instruction envelope. Install the
screws through the front or side of the trimpost
and into the cabinet to secure the oven. Do not
over-tighten the screws.
Gripping
Point
Gripping
Point
Oven gripping Points
NOTES:
1. For installation into the cabinet,
use the gripping points as
shown below.
2. Support the oven at all times,
until the oven is secured into
cabinet.
Installing the Cabinet Mounting Screws
Reinstalling the Oven doors
Grasp the oven door on opposite sides and
lift it until the door hinges are aligned with the
openings in the oven frame. Holding the door at
about a 60° angle from the horizontal, slide the
hinges into the openings until the bottom hinge
arms drop fully into the hinge receptacles.
Lower the door to the fully opened position, and
then rotate the two hinge locks toward the oven.
Open and close the door completely to ensure
that it is properly installed.
For stainless steel surfaces, peel off the
protective layer of plastic.
Remove any protective plastic from the front
of the oven and any packaging from inside the
oven.
Secure oven with screws provided. Mounting
holes are located on the front and side of
trimposts.
NOTE:
Single Models have 4 mounting
holes, 2 locations each. double
Models have 6 mounting holes, 2
locations each.
Installing the Exhaust deflector
NOTE:
Install the exhaust deflector
before installing the oven door(s).
Attach the exhaust deflector to front of the oven.
It attaches to the oven just below the oven
chamber in the door jam. On a double oven, the
exhaust deflector is mounted below the bottom
oven chamber. Line up the mounting holes on
the exhaust deflector with the screw holes on
the front of the oven. Install it using the three (3)
screws provided.
Installing the Exhaust deflector
Installation Check List

Oven is leveled. Shims may be used for
leveling of unit.

Oven is secured into cabinet (see page 7).

Exhaust deflector has been installed onto
oven (see page 7).

Doors have been re-installed onto oven
(see page 7).

Verify all packaging materials or paper has
been removed.

Verify that power supplied to oven is
correct (see page 6).

Breaker has been turned on.

Verify wall oven is operating properly (see
page 8).