Dacor ERV3015, Руководство по установке

Страница: 13 / 20

11
Installing the Raised Vent in the
Cutout
1. Cut a hole in the cabinet to allow the duct work to pass
through to the floor or wall for the planned duct system
layout. Use the dimensions on pages 7 and 8 to
determine the hole center line locations. If using the 2” x
16” to 3 1/4” x 10” transition (REMP and ILHSF blower
installations), the hole may need to be enlarged slightly.
2. Gently slide the vent into the rear of the countertop cut-
out with the electrical access panel toward the front.
3. Adjust the anchoring leg height so that the top of the
raised vent rests on the counter, then tighten the hex
nuts. Secure the anchoring legs to the cabinet floor
with the provided wood screws.
Installation Preparation for Raised Vent with
CABP3 Cabinet Blower:
1. You must remove the raised vent front cover so that the
AERVCAB cabinet blower adapter can be installed. To
do so, remove and retain the three (3) wing nuts and
three (3) flat washers on the front of the unit. Discard
the three (3) lock washers (they will be replaced). Then
tilt the cover out and pull up to remove it.
2. Peel the backing off of some of the foam tape included
with the adapter. Attach it to the right and left flanges.
3. Holding the adapter in front of the opening on the front
of the unit, line it up so that the studs are on the top
and the flanges are closest to the raised vent chassis.
4. Slide the bottom flange on the adapter into the bottom
retainer bracket on the raised vent at an angle. Attach
the adapter using the three (3) wing nuts and flat wash-
Installation Instructions
Cover
Front of unit
Rear corner of cutout
(back of raised vent)
plumbed down
Exhaust: size and location
varies with installation type
Front of unit
Floor
Top of vent resting
on countertop
Electrical access
panel
Anchor leg
Adapter
Front of unit
Bottom retainer bracket
Insert bottom
flange into
bottom retainer
bracket
Attach foam
to right/left
flanges
ers removed in step 1 and
three (3) of the lock wash-
ers from the adapter kit.