Dacor Epicure ER36DSCH, Руководство по установке

Страница: 20 / 24

Verifying Proper Operation
Prior to operating the cooktop or oven, please read the
accompanying use and care manual carefully. Important safety,
service and warranty information is contained within the use and
care manual.
Before beginning the test procedure, ensure that all cooktop
control valves are in the “ OFF ” position, and all burner
rings, burner caps and grates are properly positioned on the
cooktop frame. Turn on the gas supply at the shut-off valve.
Check for gas leaks.
Turn on power to the range.
Set the time of day:
- Press the clock key.
- Enter the time on the number keypad (within 6 seconds).
- Press START .
Press the BAKE key.
Enter the temperature of 350°F on the keypad.
Press START .
The display should show BAKE, and the preheating
temperature.
Press the
CANCEL-SECURE key to stop the oven heating
process.
Test one of the burners by pushing the knob in and turning it
counterclockwise to the HIGH position. It may take up to four
seconds for ignition to occur, at which time the ignitor will stop
sparking. If ignition does not occur within four seconds, turn
off the knob, wait for at least five minutes to allow any gas to
dissipate, then repeat the ignition test. After ignition, rotate
the control knob counterclockwise from “ HIGH ” to “ LOW ”
to adjust the flame height
progressively. When the range
is installed properly, the flame
will be steady and quiet. It will
also have a sharp, blue inner
cone that will vary in length
proportional to the burner size.
Dacor’s Smart Flame™ feature
reduces the flame under the
grate fingers to increase grate
life. If the range is equipped for
use with LP gas, the ends of
the flame may be yellow at the
tips, which is normal.
Turn the control knob to the “
OFF ” position.
Repeat the ignition test for all remaining burners.
If the range does not operate properly, follow these
troubleshooting steps:
Verify that power and gas are supplied to the range.
Check the electrical connections and gas supply to ensure
that the installation has been completed correctly.
Repeat the above bake test or burner ignition test.
If the appliance still does not work, contact Dacor Distinctive
Service at (877) 337-3226. Do not attempt to repair the appliance
yourself. Be sure to have the model and serial numbers available
when you call. See page 3 for location.
Dacor is not responsible for the cost of correcting problems
caused by a faulty installation.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
1.
2.
3.
Installation Checklist
WARNING
To ensure a safe and proper installation, the following
checklist should be completed by the installer to ensure that
no part of the installation has been overlooked.
Proper installation is the responsibility of the homeowner.
The importance of proper installation of your Dacor range
cannot be overemphasized.
•
•
Has the plastic coating been peeled off the outside of the
range? Have all packaging materials been removed from
inside the oven?
Are all leveling legs extended down to make contact with the
floor? Is the unit level? See page 7.
Is the range secured in place with the provided anti-tip
bracket and foot according to these instructions? See page 7.
If the wall in back of the cooktop is combustible, is a
backguard installed?
Is the range wired and grounded according to these
instructions and in accordance with all applicable electrical
codes? Has the electrical access cover been replaced? See
pages 4 and 10 - 15.
Has the gas supply inlet pressure been measured to ensure
that it does not exceed the maximums stated in these
instructions. See page 5.
Is the range connected to the gas supply according to these
instructions and in accordance with all applicable codes?
Did the installer check the gas supply for leaks? Has the gas
regulator cover been re-installed? See page 15.
Is the oven door properly installed according to these
instructions? See page 16.
Have the burner knobs been installed in the proper locations?
See page 17.
Are the burners and grates properly installed according to
these instructions? See page 17.
Has proper operation been verified?
Has the warranty been activated on-line or the warranty card
been filled out completely and mailed?
□
□
□
□
□
□
□
□
□
□
□
□
□
Installation Instructions
OFF Icon
Normal Flame