Dacor DTG30M954F, Руководство по установке

Страница: 29 / 144

English 29
Installation instructions
Checking for gas leaks
WARNING
To prevent an explosion/fire hazard possibly leading to personal injury or death, DO NOT
use a flame to check for gas leaks.
When using pressures above 1/2 psig to test the home gas-supply system, disconnect the
cooktop and individual shut-off valve from the gas-supply piping. When using pressures
of 1/2 psig or less to test the gas-supply system, isolate the cooktop from the system by
closing the individual shut-off valve.
1. When all connections have been made, make sure all cooktop controls are in the off
position and turn on the main gas supply valve.
2.
Use a liquid leak detector at all joints and connections to check for leaks in the system.
3.
Tighten all connections if necessary to prevent gas leakage in the cooktop or supply
line.
Making the electrical connections
WARNING
• Disconnect all electrical power at the main circuit breaker or fuse box before making
any electrical connections.
• BEFORE operating/testing, follow the grounding requirements on Page
25
of this
manual. Improper connection of the grounding plug is an electric-shock risk.
• All gas cooktops come with a power cord connected to the bottom of the cooktop
chassis. (For details, see “Electrical requirements,” page
24
.)
• The electrical system, including the power cord, is factory-installed/-wired. Altering any
part of this system may cause a short or overload.
1. Plug in the power cord. (Ensure the outlet meets all applicable electrical codes. (For
details, see Page 24 .)
2. Check the gas-supply line to verify it was not damaged and remains connected after
positioning.
Install_NA9300K_MOD_DTG30M954FS_DG68-00926A-01_EN+MES+CFR.indb 29 6/19/2018 6:49:18 PM