Dacor DTG30M954F, Руководство по установке

Страница: 22 / 144

Installation requirements
English 22
Installation requirements
Utility locations and dimensions
Front of unit
Power cord 39
3
/
8
”
(100.0 cm) long
3
/
8
”-18 NPT
male gas inlet
* Gas inlet protrudes 1
4
/
7
(4.0 cm) from
bottom.
Front of cooktop
Chassis
1¾"
(4.5 cm)
3¾"
(9.6 cm)
Gas supply requirements
Provide adequate gas supply
This cooktop is designed to operate at a pressure of 5 in (13 cm) of water column on
natural gas or 10 in (25 cm) of water column on LP gas (propane or butane).
Make sure you are supplying your cooktop with the type of gas for which it is designed.
Be sure the type of gas supplied is the same type used by this cooktop. Do not try to
convert the cooktop to receive a different type of gas without consulting the gas supplier.
This cooktop is convertible for natural or propane gas. If you decide to use LP gas,
conversion must be made by a qualified LP installer before you operate the cooktop.
For proper natural-gas operation, the pressure supplied to the regulator must be 5 in –
13 in (13 cm – 33 cm) of water column.
For LP gas, the pressure must be 10 in – 13 in (25 cm – 33 cm) of water column.
When checking for proper operation of the regulator, the inlet pressure must be at least 1
in (2.5 cm) greater than the operating (manifold) pressure as given.
The pressure regulator located at the inlet of the cooktop manifold must remain in the
supply line regardless of whether natural or LP gas is being used.
NOTE
• The cooktop with its own regulator. Use only the provided regulator, which must be
installed in the gas line that runs from the cooktop gas inlet to the gas shut-off valve.
• An external manual shut-off valve must be installed between the gas inlet and the
cooktop for turning on/off gas to the appliance.
Install_NA9300K_MOD_DTG30M954FS_DG68-00926A-01_EN+MES+CFR.indb 22 6/19/2018 6:49:16 PM