![background image](http://html.mh-extra.com/html/dab/evoplus-small-80-180-xm/evoplus-small-80-180-xm_instruction-for-installation-and-maintenance_2458952027.webp)
ENGLISH
GB
25
e57 ; e58
f < 100 Hz
f > 5 kHz
Check that the PWM external signal is
operating and connected as specified.
Energy Efficiency Index - EEI
EVOPLUS 40/180 M
0,23
EVOPLUS 60/180 M
0,22
EVOPLUS 80/180 M
0,22
EVOPLUS 110/180 M
0,22
EVOPLUS 40/180 XM
0,21
EVOPLUS 60/180 XM
0,21
EVOPLUS 80/180 XM
0,21
EVOPLUS 110/180 XM
0,21
EVOPLUS B 40/220.32 M
0,22
EVOPLUS B 60/220.32 M
0,22
EVOPLUS B 80/220.32 M
0,22
EVOPLUS B 110/220.32 M
0,22
EVOPLUS B 40/250.40 M
0,21
EVOPLUS B 60/250.40 M
0,21
EVOPLUS B 80/250.40 M
0,21
EVOPLUS B 110/250.40 M
0,21
EVOPLUS D 40/220.32 M
0,23
EVOPLUS D 60/220.32 M
0,23
EVOPLUS D 80/220.32 M
0,23
EVOPLUS D 110/220.32 M
0,23
EVOPLUS D 40/250.40 M
0,22
EVOPLUS D 60/250.40 M
0,22
EVOPLUS D 80/250.40 M
0,22
EVOPLUS D 110/250.40 M
0,22
The benchmark for the most efficient circulators is EEI ≤ 0,20.
e37
Low mains
voltage (LP)
- Switch off system power.
- Wait for the warning lights on the control
panel to go off, then power the system
again.
- Check that the mains voltage is correct,
if necessary reset it at the plate values.
e38
High mains
voltage (HP)
- Switch off system power.
- Wait for the warning lights on the control
panel to go off, then power the system
again.
- Check that the mains voltage is correct,
if necessary reset it at the plate values.
e32-e35
Critical over-
heating of
electronic parts
- Switch off system power.
- Wait for the warning lights on the control
panel to go off.
- Check that the system ventilation ducts
are not blocked and that the environ-
ment temperature of the premises is
correct.
e39-e40
Protection
against
overcurrent
- Check that the circulator turns freely.
- Check that any antifreeze added does
not exceed the maximum percentage
of 30%.
e21-e30
Voltage Error
- Switch off system power.
- Wait for the warning lights on the control
panel to go off, then power the system
again.
- Check that the mains voltage is correct,
if necessary reset it at the plate values.
e31
Twin
communication
absent
- Check that the twin communication ca-
ble is intact.
- Check that both circulators are pow-
ered.
e42
Dry operation
- Put the system under pressure.
e56
Motor excess
temperature
- Switch off system power.
- Wait for the motor to cool down
- Power the system again