ENGLISH
35
INDEX
page
1. GENERAL
35
2. WARNINGS
35
2.1 Skilled
personnel
35
2.2
Safety
35
2.3 Responsibility
35
3. TRANSPORT
36
4. INTRODUCTION
36
5.
INACTIVITY OF THE SET
36
6. INSTALLATION
36
7. TECHNICAL
DATA
36
8.
CONNECTION DIAGRAM REFERENCES: Characteristics and interpretations
36
8.1.
CONNECTION DIAGRAM REFERENCES: Key and functions
37
9. ELECTRICAL
CONNECTIONS
39
10.
SUPPLYING POWER TO THE CONTROL PANEL
39
11.
STARTING THE PANEL
39
12.
OPERATION OF THE SET WITH THE “PUMPS CONTROLLER” ELECTRONIC CONTROL UNIT
39
13.
PROGRAMMING THE “PUMPS CONTROLLER” ELECTRONIC CONTROL UNIT
40
14.
TABLE DISPLAYING PAGES AND PARAMETERS OF THE “PUMPS CONTROLLER”
ELECTRONIC CONTROL UNIT
42
15.
TABLE WITH KEY OF ALARMS DISPLAYED IN THE ELECTRIC CONTROL UNIT
“PUMPS CONTROLLER”
43
16.
TABLE OF PARAMETERS TO BE SET IN THE “PUMPS CONTROLLER” ELECTRONIC
CONTROL UNIT ONLY FOR DAB SERVICE
44
17.
TABLE OF PARAMETERS TO BE SET IN THE “PUMPS CONTROLLER” ELECTRONIC
CONTROL UNIT ONLY FOR DAB EXTENDED PROGRAMMING
46
18.
EXAMPLE OF CALIBRATING SETPOINT PRESSURE
50
19. TROUBLESHOOTING
51
LIST OF SPARE PARTS
171
1. GENERAL
Read this documentation carefully before installation.
Installation and operation must comply with the local safety regulations in force in the country in which
the product is installed. Everything must be done in a workmanlike manner.
Failure to respect the safety regulations not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
2. WARNINGS
2.1 Skilled
personnel
It is advisable that installation be carried out by competent, skilled personnel in possession of the
technical qualifications required by the specific legislation in force.
The term
skilled personnel
means persons whose training, experience and instruction, as well as their knowledge of the respective
standards and requirements for accident prevention and working conditions, have been approved by the
person in charge of plant safety, authorizing them to perform all the necessary activities, during which
they are able to recognize and avoid all dangers. (Definition for technical personnel IEC 60634)
2.2 Safety
Use is allowed only if the electric system is in possession of safety precautions in accordance with the regulations in
force in the country where the product is installed (for Italy CEI 64/2).
Ensure that the control panel has not suffered any damage during transport or storage. In particular, check that the
outer casing is unbroken and in excellent conditions and that all the internal parts of the panel (components, leads,
etc.) are completely free from traces of humidity, oxide or dirt: if needed, clean accurately and check the efficiency
of all the components in the panel; if necessary, replace any parts that are not perfectly efficient. It is indispensable
to check that all the panel leads are correctly tightened in the respective clamps.
In the event of a long storage period (or when any component has been replaced), it is advisable to perform on the
panel all the checks indicated by standards EN 60204-1.
2.3 Responsibility
The Manufacturer does not vouch for correct operation of the panel or for any damage that it may
cause if it has been tampered with, modified and/or run outside the recommended work range or in
contrast with other indications given in this manual.
The Manufacturer declines all responsibility for possible errors in this instructions manual, if due
to misprints or errors in copying. The Manufacturer reserves the right to make any modifications
to products that it may consider necessary or useful, without affecting their essential characteristics
